Wyrestorm SW-0402-MV-HDBT - 7 Using SW-0402 Console; Management Suite Installation; Connecting to a PC; Configuring the Pcs COM Port

To Next Page

To Previous Page

SW-0402-MV-HDxx Installation Guide | 170404-1529

15 of 26

North America: 844.280.WYRE (9973) | UK/EMEA: +44 (0) 1793 230 343

Email: Support@WyreStorm.com

7. Using SW-0402 Console

SW-0402 Console allows for configuring and controlling the SW-0402-MV-HDxx switchers. This software is part of the WyreStorm

Management Suite configuration tool available on most product pages on WyreStorm.com. The first step of using the SW-0402

Console is to download and install the Management Suite.

7.1 Management Suite Installation

The WyreStorm Management Suite is an All-in-One tool that allows quick and easy access to all the WyreStorm configuration tools.

With this tool software to configure Switchers, Matrixes, NetworkHD, and Enado is available under one interface. Bonjour is a

requirement to use the Management Suite and must be installed before installing the Management Suite. Follow these steps in order

to ensure that the Management Suite is installed properly and can be accessed.

1. Download the Management Suite Configuration Tool from WyreStorm.com.

2. Extract the contents of the ZIP file into a folder.

3. Run the WyreStormManagementSuiteSetup.exe file and follow the prompts to complete the installation.

4. Launch the Management Suite to verify the installation.

7.2 Connecting to a PC

The PC Console communicates with the scaler via RS-232 serial from a PCs USB port with a COM adapter (not included).

Refer to the RS-232 Wiring section for the proper pinout.

7.3 Configuring the PCs COM Port

Before communicating with the scaler, the PCs com port settings must be set to match the scalers COM settings.

1. Connect the COM adapter to the PC. Wait for any install process to complete.

2. Open Device Manager on the PC.

3. Navigate to, Ports (COM & LPT).

4. Select the Expansion Triangle to expand the list of ports.

5. Right click on the port and select Properties.

6. In the open dialog, select the Port Settings tab.

7. Enter the following values:

Bits per Second (Baud Rate):

115200

Parity:

None

Data Bit:

Stop Bit:

Row Control:

None

8. Once the values are entered, select OK to save the values.

Other manuals for Wyrestorm SW-0402-MV-HDBT