© Copyright 2017 WyreStorm Technologies | WyreStorm.com
SW-0402-MV-HDxx Installation Guide | 170404-1529
North America: 844.280.WYRE (9973) | UK/EMEA: +44 (0) 1793 230 343
Email: Support@WyreStorm.com
7.9 Preset Tab Overview
The Preset tab can be used to save up to 20 custom multi-view configurations. To save a custom multi-view configuration perform
the following. Created pre-sets are accessible by the SW-0402 Console or through an RS-232/IP Control system such as Enado. The
Enado template and the 3
rd
party drivers contain access to these pre-sets. Visit the product page to download the available drivers.
1. Configure the desired multi-view layout in the HDMV tab
2. Navigating to the PRESET tab.
3. Select the PRESET number that the layout will be saved to.
4. Click the Save MV Setting button.
5. Give the saved PRESET a name by editing the field with the asterisk.
Saves currently configured layout on the HDMV tab to the selected preset
Recalls multi-view layout saved to preset
Alias can be entered to better identify saved preset
Sets VGA inputs to auto size based on display connected
7.10 Configuring the Network Connection
The scaler’s network connection can be configured to obtain an IP Address from a router using Dynamic Host Configuration Protocol
(DHCP) or be set manually to a static IP Address. The scaler is configured for DHCP by default, WyreStorm recommends that a static
IP is used to ensure that the IP Address to the scaler will not change.
IMPORTANT!
Setting network values incorrectly can prevent the scaler from connecting to the network. Ensure that all network information is
correct before making any changes to the IP Settings.
To Set a Static IP Address (Manual Configuration)
1. On the PC, navigate to the folder for the PC Console software. Open the PC Console.
2. Navigate to the IP Setting tab.
3. Uncheck the box next DHCP.
4. Next to Host IP Address, enter an IP address for the scaler.
To Next Page
Loading...
