© Copyright 2017 WyreStorm Technologies | WyreStorm.com
SW-0402-MV-HDxx Installation Guide | 170404-1529
North America: 844.280.WYRE (9973) | UK/EMEA: +44 (0) 1793 230 343
Email: Support@WyreStorm.com
Read the EDID from a Display (Output)
1. Select the output to read the EDID from.
Out 1 or Out 2.
2. Select Read EDID.
3. Select the input to write the EDID to. Note that there is a section for HDMI and one for VGA.
4. Select Write EDID to xxxx Input Port.
Note: xxxx represents either HDMI or VGA depending on which port is desired to be changed.
Resetting EDIDs
1. Select the output to reset.
All4 | In1 | In2 | in3 | In4
2. Select xxxx EDID Reset.
Note: xxxx represents either HDMI or VGA depending on which port is desired to be reset.
To Next Page
Loading...
