AC input and output indicator.
The wrench icon underneath a number is displayed
du
ring configuration mode.
An error event with its co
rresponding number is
displayed here.
A warning event with its cor
responding number is
displayed here.
The battery icon indicates remaining battery power.
One
bar = 1-25%, two bars = 25-50%, three bars = 50-
75%, and four bars = 75-100%.
Shows an overload condition.
The load icon is displayed if there is voltage
available
at the AC output.
The bar represents load consumption levels. 100% is
an indication of full capacity and 25% indicates low
consumption. All the bars disappear at < 20 watts, and
AC load indicates zero watt power.
Shows up in grid mode when AC shore power is
present. If the power is being qualified, then this icon
will flash.
Shows that the unit is in grid
mode and is bypassing
shore power directly to the loads.
This icon shows when there is
power conversion from
DC to AC - inverting.
The alarm buzzer is muted.
Icon Definition
Freedom X Series INV Owners Guide.book Page 41 Tuesday, June 27, 2017 4:10 PM
To Next Page
Loading...
