975-0753-01-01 29
This guide for use by qualified personnel only.
Marine Installation
Figure 9 illustrates a typical marine installation with the following
components:
1. AC power supplied from a shore power connector
2. An AC source panel that includes a Max 30A circuit breaker
that supplies
the Freedom Xi
3. An AC load panel with branch circuit breakers that supply only
loads
that run off the Freedom Xi
4. Engine negative bus / DC ground bus
5. DC power supplied by a battery bank and protected by a DC
fu
se in the positive cable
6. Battery isolator
7. DC alternator
8. Starting battery
9. Drip shield (see next page)
Figure 9 Typical Marine Installation
To Next Page
Loading...
