Section 1. Features and Specifications
Rear Panel Connectors and Outputs
Release 1.2 13
Figure 1.2 shows the programming interface indicators for units that have a digital
programming interface installed.
Figure 1.2 Remote Programming Interface Indicators
Rear Panel Connectors and Outputs
Figure 1.3 shows the connectors and outputs available at the rear panel. (Figure 1.3
shows the 15 V or 30 V low voltage model.)
Figure 1.3 Rear Panel
Remote Programming LED (REM)
Shutdown LED (SRQ)
OVP Shutdown (OVP)
OVP Adjust Potentiometer (OVP ADJ)
AC Input Connector
Blank Subplate
(Replaced if a programming
option is installed.)
Output Barrier Strip
Output Block for
High Voltage (60 V) Model
Note
The power supply is shipped with jumpers for local sensing of the output voltage. See
“Local Sensing” on page 29.
To Next Page
Loading...
