Section 3. Load Connection and Sensing
Local Sensing
30 Operating Manual for HPD Series Power Supply
Figure 3.2 Output Barrier Strip With Jumpers Installed
High Voltage Models Two wire jumpers are shipped unattached with 60 V
models. If your application requires precisely regulated output voltage at the rear
output terminals, install the jumpers by inserting the jumper wires into the jumper
terminals as shown. See Figure 3.3.
Figure 3.3 Output Terminal Block With Jumpers Installed
Positive Remote
Sense Line (+SNS)
Jumper
Negative Remote
Sense Line (−SNS)
Negative Output
Te r mi nal (−)
Positive Output
Ter m ina l (+)
Wire
Jumper
To Next Page
Loading...
