About Link 1000 Settings
24
Changing the Ambient Temperature Setting
When you have a battery temperature sensor:
If you have a
battery temperature sensor:
1. Leave the default Ambient Temperature setting as is.
2. Turn on Active Temperature Compensation (F16).
(See
page 34.)
When you do not have a battery temperature sensor:
If you
do not have a battery temperature sensor, and if the
temperature around the battery will be substantially different
from 70 °F (21 °C) when the batteries are being charged:
1. Turn the Active Temperature Compensation setting Off.
(See page 34.)
2. Change the Ambient Temperature setting to an
appropriate value.
To change the Ambient Temperature setting:
1. Press and hold
SET until SEL appears.
2. Press
SEL until Func 03 appears.
3. Press
SET to change the temperature in 10 °F increments.
4. Release
SET when the correct temperature appears.
Note: The Active Temperature Compensation setting must be
Off if you are going to change the Ambient Temperature setting.
Otherwise the Link 1000 reports the present battery temperature.
To Next Page
Loading...
