Xantrex MS2000 - System Modes; Figure 2-2 System Control Panel

Operation
2–6 975-0125-02-01
System Modes
This section provides an overview of the four different system modes.
The system modes described in this section affect the performance and behavior
of the MS2000 and all other Xanbus-enabled devices on the Xanbus system.
You’ll have to change the system mode when putting your boat in storage, or
when installing a Xanbus-enabled device.
You can change system modes using the System Settings menu on the System
Control Panel.
You can also use the red System button on the System Control Panel to put the
System Control Panel and all other Xanbus-enabled devices into Power Save
mode only.
System modes are changed using the System Settings menu. The four system
modes are:
• Operate
• Power Save
• Safe
• Hibernate
Please read the section about each system mode to find out which mode is
appropriate for different conditions or situations.
Figure 2-2 System Control Panel
button
System