Xantrex Trace DR Series User Manual

29
2.0 INSTALLATION
©2000 Xantrex Technology Inc.
FROM
UTILITY
120 VAC INVERTER OUT
MAIN PANEL
120 VAC FROM
INVERTER
UTILITY FEED
FROM METER
SUB PANEL
INVERTER/CHARGER
GROUND
NEUTRAL
120 VAC LINE IN
LINE OUT
120 VAC LINE OUT
NEUTRAL
GROUND
LINE OUT
NEUTRAL
GROUND
NEUTRAL
NEUTRAL
LINE
1
LINE OUT
GROUND
EXISTING HOUSE WIRING
120 VAC BACKUP POWER
TO LOAD
(NEW WIRING)
DISCONNECT
MAIN
BREAKER
NOTE: FOR ILLUSTRATIVE PURPOSES ONLY.
BREAKER BOXES VARY DEPENDING ON APPLICATION.
MAIN PANEL WIRING TO NON-CRITICAL LOADS
IS NOT ILLUSTRATED.
EARTH GROUND
120 VAC BACKUP POWER
TO LOAD
120 VAC
120 VAC
240 VAC
GROUND
CAUTION:
NEUTRAL BONDED TO GROUND
IN MAIN PANEL ONLY!
NEUTRAL
3597-W00-C06
Figure 25
Single Inverter 120 VAC Wiring Diagram
AC Wiring (continued)
AC Input Wiring to the Main Utility Breaker Box (single inverter installations)
WARNING: MAKE CERTAIN THE POWER TO THE MAIN UTILITY BOX IS DISCONNECTED!
NEVER WORK ON LIVE CIRCUITS.
 Remove the MAIN UTILITY BOXs cover plate.
 Connect the ground (green) wire to the GROUND bus in the main utility box.
 Connect the neutral (white) wire to the NEUTRAL bus.
 Connect the hot (black) wire to the 60 amp circuit breaker (installed for the inverter).
 Torque all wires to the manufacturers specifications.
CAUTION: INSPECT ALL WIRING FOR PROPER INSTALLATION BEFORE REINSTALLING THE
COVER PLATE.

Xantrex Trace DR Series Specifications

General

Brand	Xantrex
Model	Trace DR Series
Category	Battery Charger
Language	English