Xerox 4110

Xerox 4590/4110 Copier/Printer Getting Started
1-10
1. Product Overview
Power off
Perform the following to power off the machine:
1. Before switching off the power ensure that all copy or print jobs
have completely finished. Furthermore, ensure that the
<Online> indicator is not lit.
KEY POINT 1: Switching off the power before copy/print jobs
are complete loses any data that is being processed.
KEY POINT 2: Never switch off the power while:
– While data is being received
– While jobs are being printed.
– While jobs are being copied
– While a scan is being executed
2. Press the power switch to the off position [ ].
KEY POINT:The power off process continues internally after
the power switch is turned off. Therefore, do not immediately
unplug the power cord from the power outlet.
NOTE: If you have switched off the power, wait ten seconds
before switching on the power again.
About the circuit breaker
This product is equipped with a circuit breaker.
The circuit breaker is normally On ("l") position, as shown in the
figure. If power to the machine is interrupted, the circuit breaker
trips and the switch is in the Off (“O”) position.
If the breaker is Off ("O") position, contact your Customer Support
Center as there might be some unusual conditions.