XES Synergix 8825/8830/8850/8855 & X2-TECH System Introduction 71
Printer Feature Description/Specifications
Print Job Input
Host Interfaces RS232C Serial, Ultra SCSI (standard on version N5T/CNG, optional on EV4 controller), IEEE 1284 Parallel, Ethernet. Optional
VPI (standard on version N5T/CNG, optional on EV4 controller - VPI is for input only.)
Network Protocols Optional NIC (10BaseT Ethernet) for N5T/CNG motherboard only (non-tower version): EtherTalk, TCP/IP (lpr/lpd, application
socket, telnet, TFTP puts,...), Novell IPX/SPX PServer for Ver. 3.x and 4.x w/NDS, NetBeui
AccXES N5T/CNG and EV4 Controllers (10/100BaseTX): High speed, multiple session TCP/IP (lpr/lpd, application socket, TFTP
puts, FTP, ping, )
TCP/IP protocol support IP Address Resolution: DHCP, BOOTP, RARP
Wide area network support (default gateway, netmask parameters)
Automatic Active Port Sensing Yes
Job Spooling/Queuing Internal to controller: 143 MB+ hard disk
Job Queue Management Single Prioritized queue, adjustable pre and post-render job priority, job canceling, queue monitoring, resource based scheduling.
To Next Page
Loading...
Need help?
General