Back to Previous Page
8
Add the Printer to the Network
Next
Back to Start
Connect the printer to the network router with an
Ethernet cord and configure the printer for a
wired connection. (Wi-Fi is on by default and
needs to be turned off.)
Perform these steps from the printer’s control panel.
1. Press the System Information/ Machine Status button
2. Use the Down arrow and OK button to follow this navigation pathway: Network >
Wi-Fi > Wi-Fi ON.
3. Change Wi-Fi ON to Wi-Fi OFF then press OK. Press the back button.
4. Select DHCP to have the router assign a dynamic IP address, then press OK.
5. Press the System Information/ Machine Status button to return home.
To Next Page
Loading...
