Fold Adjustment information
Note
The Adjust Fold option is available only if your finisher has the optional C/Z Folder
attached to it.
• Bi-Fold adjustment: A Bi-Fold has one fold which creates two panels to the output.
The following illustration reflects a Bi-Fold Single Sheet:
Multiple sheets or multiple sheets with staples can also be added to a Bi-Fold
adjustment as depicted in the following illustrations:
• C-Fold: A C-Fold has two folds which creates a three-panel output. The following
illustration reflects a C-Fold adjustment:
• Z-Fold: A Z-Fold has two folds that are folded in opposite directions, resulting in a
type of fan fold. The following illustration reflects a Z-Fold adjustment:
- Z-Fold Half Sheet: As with a regular Z-Fold, it has two folds that are folded in the
opposite directions. The difference between a regular Z-Fold and a Z-Fold Half
Sheet is that the Z-Fold Half Sheet is not folded in two equal folds. The two folds
are unequal which allows one edge of the Z-Fold Half Sheet to have a longer edge,
and the longer edge allows for stapling or hole punching. Refer to the following
illustration:
6-13
Xerox
®
Color 800/1000 Press
System Administration Guide
Profiles
To Next Page
Loading...
