Xerox D125 User Manual

012-400
Cause: Staple Waste Container near full
Remedy: Follow the procedures to remove and replace the staple waste container in
the finisher.
012-949
Cause: Punch Waste Container is not attached
Remedy: Check that the punch waste container is installed in the finisher and inserted
correctly.
024-931
Cause: The Staple Waste Container is full or near full
Remedy: Remove the Staple Waste Container and install a new one.
024-932
Cause: The Staple Waste Container is not attached
Remedy: Check that the Staple Waste Container is installed in the finisher and inserted
correctly.
024-943
Cause: The booklet staple cartridge is empty or stapling error occurred.
Remedy: Perform the following:
• Check the staple cartridge and reset correctly.
• If necessary, replace with a new cartridge.
• Resume job.
024-957
Cause: Post-Process Inserter Tray (Tray 8/T1) is empty or out of paper
Remedy: Add paper to the paper tray.
024-974
Cause: When feeding paper from the Post-Process Inserter Tray, the designated paper
size and the actual size of paper in the tray differ.
Remedy: Reset/change the paper or cancel the job.
024-976
Cause: Finisher staple fault
Remedy: Check staples and reset correctly.
024-977
Cause: Finisher staple feeding is not ready.
Remedy: Check staples and reset correctly.
024-978
Cause: Booklet maker finisher staple operation is not ready.
22-45Xerox
®
D95/D110/D125/D136 Copier/Printer
User Guide
Standard/Booklet Maker Finisher

Xerox D125 Specifications

General

Print Speed	Up to 125 ppm
Print Resolution	2400 x 2400 dpi
Standard Paper Capacity	4, 050 sheets
Maximum Paper Capacity	8, 050 sheets
Connectivity	Ethernet, USB
Duplex Printing	Standard