Power off/on the machine, and if necessary, resend/restart your print job.
If the error persists, contact the Customer Support Center.
112-700
Cause: The Punch Waste Container is full or near full
Remedy: Remove and empty the waste container, then reinstall it.
116-790
Cause: The settings for stapling are canceled and prints the data
Remedy: Confirm the staple position and try to print again.
124-705
Cause: The settings for punching are canceled
Remedy: Confirm the punching position and try to print again.
124-706
Cause: The settings for folding are canceled
Remedy: Confirm the folding settings and try to print again.
124-709
Cause: The number of pages exceeds the number of pages that can be stapled
Remedy: Decrease the number of pages, or cancel the stapling settings, then try to
print again.
Specifications
Standard/Booklet Maker Finisher
SpecificationItem
• Top Tray: Collated/Uncollated
Note
Transparencies can be sent to the TOP tray of the finisher ONLY.
Transparencies cannot be sent to the stacker (middle) tray.
• Stacker (middle) Tray: Collated/Uncollated (Offset available)
Tray Type
22-47Xerox
®
D95/D110/D125/D136 Copier/Printer
User Guide
Standard/Booklet Maker Finisher
To Next Page
Loading...
Need help?
General