Paper Tray Attributes During Loading
When a paper tray is removed from the machine and then replaced, selecting Disabled
or Enabled determines whether or not the tray change is displayed on the UI.
1. From the Paper Tray Settings select Paper Tray Attributes During Loading.
2. Select one of the following:
• Off: If this feature is selected, then the UI does not display the paper tray attributes
while you are loading paper in the tray.
• On: If this feature is selected, the UI displays the paper tray attributes as you are
loading paper into the tray
3. From the Paper Tray Settings screen, select Paper Tray Priority.
Paper Tray Priority
Set the paper tray priority sequence for automatic tray selection. Automatic tray
selection means that a tray containing the appropriate paper is automatically selected
by the machine for copying or printing.
You can select paper trays 1-4 and optional 6 and 7. Tray 5 (Bypass) cannot be
selected.
4. Select the item to be set or changed, and select Change Settings.
5. Select a Priority setting (First-Sixth) and assign a specific tray to that priority setting.
Note
Only one tray can be set to each priority.
6. Select Save to save the selections and return to the Paper Tray Priority screen.
7. Select Close to return to the Paper Tray Settings screen.
Paper Size
Standard-sized paper that is loaded into trays 3, 4, and optional trays 6 and 7 is
automatically detected. However, when a nonstandard size is loaded, it is necessary to
specify the width and height.
Tip
Depending on the paper size, the guide lever may not fit, and this may cause paper jams
or other errors. Tray detection may also not be possible. In such cases, use tray 5 (Bypass
Tray).
Note
Trays 1 and 2 are preset at manufacturing at size 8.5 x 11 in. (A4); therefore, the paper
size for these two trays cannot be changed on this screen.
Paper Type Priority
1. Select Paper Type Priority.
Xerox
®
D95/D110/D125/D136 Copier/Printer10-32
System Administration Guide
System Settings
To Next Page
Loading...
Need help?
General