What to do if the display is dark on my Xerox D136?
If the display on your Xerox Copier is dark, press the Power Saver button on the Control Panel to cancel the Power Saver mode. If that doesn't work, adjust the display brightness using the Brightness dial.
What to do if Xerox Printer documents jam often?
To prevent frequent document jams, ensure the document feeder is properly loaded with acceptable media. Remove any sticky labels, paper clips, or tape from the documents. Properly set the document guides and check for any paper pieces inside the document feeder cover. If you're using mixed-size originals, set the Mixed Size Originals option to ON. When loading A5-size documents, load them vertically.
How to turn on Xerox Printer if power is not switched on?
If the power is not on, first, ensure the power switch is turned on. If it still doesn't power on, turn the power switch off, then firmly plug in the power cord before turning the power switch back on. Also, confirm that the power supply is within the range of 200-240 V and 15 A, and that the power capacity is compatible with the printer's maximum power consumption of 2.8-3.1 KVA.
Why is my Xerox Printer unable to print or copy?
If you're unable to print or copy, first follow any instructions displayed on the printer's screen. Next, press the Machine Status button and select Online from the Printer Mode. If the issue persists, turn the power switch off, firmly plug in the power cord, and then turn the power switch back on.
What to do if copies are not delivered with Online still lit on my Xerox D136 Copier?
If the online indicator lights on your Xerox Copier, but copies are not delivered with Online still lit, cancel printing, or purge remaining data.
What to do if a corner of the document is folded in my Xerox D136?
If a corner of the document is folded when using your Xerox Copier, flatten out the curl and load the document again.
What to do if my Xerox Printer displays fault code 127-311?
If your Xerox printer displays fault code 127-311, it indicates that a fatal error was detected by the controller. Try power cycling both the controller and the printer (turn them off and then on again). If the problem persists, you should contact the Customer Support Center.
How to fix Xerox Printer when copies are not made at the desired size?
If your copies are not the correct size, start by cleaning the document feeder glass or the document cover. When copying, place the document on the document glass and put a white sheet of paper on top. Ensure the document is loaded correctly, the document guides are properly set, and the document is straightened. Finally, make sure you've entered the correct document size.
What to do if Tray 5 (Bypass) printing failed on my Xerox D136 Copier?
If the Tray 5 (Bypass) printing failed on your Xerox Copier, follow the instructions displayed to load paper of the correct size and try printing again.
Why do documents jam often in my Xerox D136?
If documents jam often in your Xerox Copier, make sure the document feeder is loaded properly with acceptable media. Remove any sticky labels, paper clips, or tape from the documents. Properly set the document guides. Open the document feeder cover and check for pieces of paper. Set Mixed Size Originals to ON. Load the A5-size document vertically.
To Next Page
General
