Xerox DocuMate 150 - Step 1: Assemble the Scanner

DocuMate 150 Scanner User’s Guide 5
Installation
Step 1: Assemble the Scanner
1. Remove the scanner from its protective foam and plastic bag.
2. Open the ADF cover and carefully remove any foam particles that
may have gotten inside it.
3. Align the tabs on the Input tray with the slots inside the scanner and
slide the tray down into place.
4. Swing the paper guide back until it snaps into place. Close the
scanner cover. Flip the paper guide extension up so it is fully
extended.
5. Insert the pins on each side of the output tray into the holes on the
scanner. Flip open the extension on the output tray so it is fully
extended.