TWAIN Scanning Guide Driver Configuration
50 User’s Guide
Scanner Configuration
The scanner configuration tab shows the hardware information for your scanner. Some features
described herein may not be available for the current scanner. Please disregard any information
about features that you do not see in the interface for your scanner.
Scanner Details
• Firmware version—this is the scanner’s hardware processor version number.
• Serial number—the scanner’s unique identification number.
• LLD version—the scanner’s base driver version. This is not the OneTouch software revision,
TWAIN or WIA driver versions.
• Driver version—this is the version of the scanner’s TWAIN driver.
Scanner Settings
• Counters—click the reset button next to the counter you want to set back to 0.
Power Settings
• Sleep mode—sleep mode is the low-power state when the scanner is not in use. You can
adjust the amount of time you want the scanner to wait before it goes into low power.
Click the green enter button to save any changes in the Sleep mode field.
Click the red reset button to reset to the default timeout value.
• Power off—input the number of minutes you want the scanner to wait before it turns itself
off.
Click the green enter button to save any changes in the power off field.
Click the red reset button to reset to the default timeout value.
• Reset device—click this button to revert the scanner hardware back to the scanner’s
firmware defaults. As this option resets the scanner hardware, you will not see a change in the
interface unless the power save time has been changed. Clicking this button includes
returning the power save time-out to the default setting.
To Next Page
Loading...
Need help?
General