TWAIN Scanning Guide Hardware Properties and Interface Behavior
52 User’s Guide
The options in this panel may also appear on the scanner configuration tab in the TWAIN
interface. Please refer to the “Scanner Configuration” section of this guide for instructions on using
these options:
• Sleep mode
• Power off
• Reset device
•Counters
Scanner Details
• Firmware version—this is the scanner’s hardware processor version number.
• Serial number—the scanner’s unique identification number.
• LLD version—the scanner’s base driver version. This is not the OneTouch software revision,
TWAIN or WIA driver versions.
• Driver version—this is the version of the scanner’s TWAIN driver.
Firmware Update
• Check for update—check the scanner’s firmware version against the version included with
the scanner driver. When the scanner is connected to the computer and this option is
selected, or when a different scanner of the same model is connected, a notification will show
indicating that the firmware version is out of date. Deselect this option to stop being notified
of the different version if you do not want to update the firmware.
• Update—click this button to update the scanner’s firmware with the latest revision provided
in the driver installer. Follow the instructions on-screen to update the scanner’s firmware. Do
not turn off the scanner or close any on-screen dialogues while the firmware update is in
process. Turning off the scanner or closing any on-screen dialogues before you are prompted
could irrevocably damage the scanner and prevent it from working. The firmware update
software will prompt you when it is safe to power cycle the scanner.
Power adjustments
• Turn lamp on and Turn lamp off—click either of these buttons to immediately turn the
scanner lamp on or off.
To Next Page
Loading...
Need help?
General