Scanning From One Touch DocuMate 742
2-16 User’s Guide
5. The item is scanned. When finished, click the Done button and the image will be sent to the
Destination Application specified in the One Touch 4.0 Properties window.
In the example shown on the previous page, the Destination Application is Paint.
Canceling a Configure Before Scan
1. Click Cancel in the scanning progress window.
2. The following window will open asking if you want to cancel the entire job.
• Yes—Scanning stops and all pages scanned in this batch, up to this point, will be
deleted. The TWAIN interface will close and you can restart your scan from the
beginning.
Choose Yes if the TWAIN scan settings are incorrect for your current scanning batch.
For instance, the Picture Type is Black & White but you want to scan your documents in
color. Choose Yes to delete any scanned pages, then start over but select the correct
picture type before scanning.
• No—Scanning stops, but all pages scanned in this batch, up to this point, are not
deleted and the TWAIN interface remains open. You can place a new page in the
scanner, adjust the TWAIN settings for it, then click the Scan button in the TWAIN
interface to continue scanning. At the end of the scanning batch, all pages from the
first portion of the scan and second will be sent to the Destination Application.
Choose this option if, for instance, you have been scanning a Black & White document
but you want to insert a color page into it. Instead of having to re-scan the entire
batch, you can stop the current scan, change the picture type from Black & White to
Color, then restart the scanning without losing the pages already scanned.
To Next Page
Loading...
Need help?
General