Setting Up Your Printer
2.
4
5
Flex the paper sheets back and forth to separate the pages
and then fan them while holding one edge. Tap the edges
of the stack on a flat surface to even it up.
6
Load paper
with the
print side up
.
Make sure not to overfill the tray and that all four corners
are flat in the tray and under the brackets, as shown
below. Overfilling the tray may cause a paper jam.
NOTE
:
If you want to change the size of the paper in the tray,
refer to “Changing the Size of the Paper in the Tray” on
page 2.5.
7
Squeeze the paper length guide and slide in it until it
lightly touches the end of the paper stack.
8
Close the paper cover.
9
Slide the tray back into the printer.
NOTE
:
After you load paper, you need to set up your printer
for the paper type, size, and source you loaded. For details,
see the
Software Section
.
To Next Page
Loading...
