Xerox PHASER 7500 User Manual

Troubleshooting
Phaser 7500 Color Printer
User Guide
109
Printing Takes Too Long
Printer Resets or Turns Off Frequently
Probable Causes Solutions
The printer is set to a slower printing mode (for
example, heavyweight stock or transparency).
It takes more time to print with special media. Make
sure that the media type is set properly in the driver
and at the printer’s control panel.
The printer is in ENERGY SAVE mode. It takes time for printing to start in power saving
mode.
The job is very complex. Wait. No action needed.
Probable Causes Solutions
The power cord is not correctly plugged into the
outlet.
Turn off the printer, confirm that the power cord is
correctly plugged into the printer and the outlet, and
then turn on the printer.
A system error occurred. Contact your local Xerox service representative with
the fault information. Check the fault history. For
more information see Control Panel Messages on
page 143.

Xerox PHASER 7500 Specifications

General

Max Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	150, 000 pages
Standard Paper Capacity	550 sheets
Duplex Printing	Optional
Standard Memory	256 MB
Network Connectivity	10/100/1000Base-T Ethernet
Supported Operating Systems	Windows, Mac OS, Linux
Max Paper Capacity	2, 100 sheets
Connectivity	USB 2.0, Ethernet
PDL	PostScript 3, PCL 6, PDF
Print Speed	Up to 35 ppm