Xerox VersaLink B610

PAPER TRAY WILL NOT CLOSE
PPRROOBBAABBLLEE CCAAUUSSEESS SSOOLLUUTTIIOONNSS
The paper tray does not fully close.
• If the tray is extended for legal-size paper, the tray
protrudes when it is inserted into the printer. For
more information, refer to Configuring Trays 1 or 2
for the Paper Length.
• Some debris or an object is blocking the tray.
• The tray is blocked by the table or shelf on which it
is located.
• If the paper lift plate at the back of the tray is not
locked down, replace the tray.
CONDENSATION HAS FORMED INSIDE THE PRINTER
Moisture can condense in the printer when room humidity exceeds 85% or when a cold printer is located in a warm
room. Condensation can form in a printer after it has been sitting in a cold room that is heated quickly.
PPRROOBBAABBLLEE CCAAUUSSEESS SSOOLLUUTTIIOONNSS
The printer has been sitting in a cold
room.
Allow the printer to operate for several hours at room temperature.
The relative humidity of the room is too
high.
• Reduce the humidity in the room.
• Move the printer to a location where the temperature and
relative humidity are within the operating specifications. For
more information, refer to Environmental Specifications.
154
Xerox
®
VersaLink
®
B600/B610 Printer User Guide
Troubleshooting