Xerox Versant 4100 Press - Page 13

Xerox Customized Envelope Feeder – Problem Solving Guide 3-3
Toreducethelikelihoodofmorethanoneenvelopedischargingatonce,increasethefrictiononthe
separatorbyturningthe“DONOTADJUST”knobinthecenterofthefeedercounterclockwise.Thiswill
lowertheO‐ringsonthebottomoftheseparatorassembly.














Loweringthe
separator(increasefrictionforbetterseparation)

Ifyoudoturnpastthestop,besuretodouble
checkthattheseparatorassemblydidnotjump
outoftheJ‐channelsinthefeede
r
(seebelow).
NOTE:Ifthethreadedstud(bluearrow)no
longerturnsduetothestop(redarrow),youcan
liftthe“donotadjustknob” overthestopand
continueturningtheknob(seebelow).
A, B, AND C Models Only