4-6 Xerox Customized Envelope Feeder – Problem Solving Guide
REP 4.5 Separator O-Ring Replacement
Replace the Separator Assembly O-rings when they show wear and after they have been advanced
(REP 4.4) to the point where there is no longer a non-flat section available.
1. Turn the power switch to the Off position and remove the power cord from the power source.
2. Remove the Separator Assembly from the Separator Bracket by pushing down on the
Separator Barrel while lifting up on the Separator Adjustment Knob. Repeat when re-
installing.
To Next Page
Loading...
