Xerox WorkCentre Pro 123 - Page 167

Properties
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 User Guide 167
Port Status Port Status
Allows you to select whether to enable or disable different
ports used on the machine.
Parallel – Allows you to select the check box to enable.
USB – Allows you to select the check box to enable.
EtherTalk – Allows you to select the check box to enable.
SMB – Allows you to select check box to enable. You can
also configure the transport protocol to be used. To enable
the transport protocol, select the check box of TCP/IP and/or
NetBEUI.
NetWare – Allows you to select check box to enable. You
can also configure the transport protocol to be used. To
enable the transport protocol, select the check box of IPX/
SPX and/or TCP/IP.
LPD – Allows you to select the check box to enable.
SNMP – Allows you to select the check box to enable. You
can also configure the transport protocol to be used. To
enable the transport protocol, select the check box of UDP
and/or IPX.
IPP – Allows you to select the check box to enable.
Port9100 – Allows you to select the check box to enable.
UPnP – Allows you to select the check box to enable.
FTP Client – Allows you to select the check box to enable.
Receive E-mail – Allows you to select the check box to
enable.
Mail Notice Service – Allows you to select the check box to
enable.
Internet Services – Allows you to select the check box to
enable.
SOAP – Allows you to select the check box to enable.
Port Settings Ethernet
Allows you to select the ethernet transmission rate.
Ethernet Settings – You can select one of the following
options.
• Auto: Detects the ethernet transmission rate
automatically.
• 10BASE-T(Half Duplex): Selects 10BASE-T (in half duplex)
as the default value.
• 10BASE-T(Full Duplex): Selects 10BASE-T (in full duplex)
as the default value.
• 100BASE-T(Half Duplex): Selects 100BASE-T (in half
duplex) as the default value.
• 100BASE-T(Full Duplex): Selects 100BASE-T (in full
duplex) as the default value.
MAC Address – Displays the MAC address of the machine.
This is a display-only item.
Feature Setting items