9
Power Reduction / Auto Clear
Power Reduction Modes automatically reduce power consumed by the
copier when the copier has not been used for a set period of time. There
are two modes.
1. Power Save Mode – In this mode, the fuser is maintained at a lower
heat level, thereby saving power. The Ready Indicator will flash and
the other indicators will remain on. To copy from the Power Save
mode select the desired features and press Start. The copies will be
made automatically.
2. Power Shut-off Mode – This mode saves more power than the Power
Save Mode, but requires more time before copying can restart. When
the copier enters the power shut-off mode the Ready Indicator will
flash and the other indicators will turn off. To copy from the Power
Shut-off mode, press Start, select the desired features and press Start
again. The copies will be made automatically.
Auto Clear – The copier returns to normal copy mode approximately one
minute after a job is completed. Unless otherwise programmed, the
normal copy mode settings are as follows:
• Copy Quality – Auto
• Copy lighter/darker – Normal
• Priority Tray – Tray 1
• Priority Magnification – 100%
• Quality Selected – 1
Note: The time periods for the Power Shut-off, Power Save, and Auto
Clear modes can be modified to meet your specific copying needs. Refer
to Customising Your Copier section of this User Guide for information
about changing these settings.
To Next Page
Loading...
Need help?
General
