Press [MENU] key to enter the function. Press the / keys to select the always on/required delay time (ON/5sec/5sec/10sec/15sec/20sec)
the backlight of the display, then press [MENU] key to confirm.
To return to the standby mode press [EXIT] key.
6.9.2 Beep PROMPT (BEEP) - MENU 32
If you enable this function, every time a key is pressed, you will hear a Beep tone.
In standby mode, press [MENU] + 3 2. The screen will display “BEEP PROMPT”.
Press [MENU] key to enter the function. Press the
/ keys to turn ON/OFF the beep function.
Press [MENU] key to confirm and exit to return to stand-by mode.
6.9.3 Voice function (VOICE) - MENU 30
In standby mode, press [MENU] + 3 0; the screen will display “VOICE”.
Press [MENU] key to enter the function. Press the
/ keys to select OFF/ON. Confirm your selection by pressing MENU.
To return to the standby mode press [EXIT] key.
6.9.4 Language of the MENU (LANGUAGE) - MENU 29
This section shows the language of the MENU (English).
In standby mode press [MENU] + 2 9. The display will show “LANGUAGE”.
6.9.5 Working Mode (MDF-A) - MENU 39
The radio has four working modes available:
• Frequency mode (FREQ)
• Channel mode (CH)
• Channel name (NAME)
To shift from one mode to another one:
In Standby mode press [MENU] + 3 9; select the desired working mode with the
/ keys.
Press [MENU] key again to confirm your selection.
6.9.6 Roger Beep, end Transmission Tone (ROGER) - MENU 33
Roger Beep can be enabled/disabled:
• OFF: Roger Beep disabled
To Next Page
Loading...