• BEEP: Roger Beep tone at the end of transmission
In standby mode, press [MENU] + 3 3; the screen will display “ROGER”.
Press [MENU] to enter the function. Press the
/ keys to select OFF/ON. Confirm your selection by press [MENU] key.
To return to the standby mode press [EXIT] key.
6.9.7 Power On Message (POWER ON MSG) - MENU 40
With this Menu you can customize the welcome message that appears on the display when the radio is switched on.
Choose amongst the following options:
• VOLTAGE (the power voltage is momentarily displayed)
• MESSAGE (welcome message)
• LOGO (Custom Pictures)
In Standby mode press [MENU] + 4 0. The display will show “POWER ON MSG”.
Press [MENU] key to enter the function. Press the
/ keys to select the desired option and confirm with MENU.
To return to the standby mode, press [EXIT] key.
6.9.8 Power On Password (Power On PWD) - Menu 37
With this Menu you can request the correct password when the radio is turned on.
In standby mode, press MENU + 3 7. The display will show "POWER ON PWD"
Press [MENU] key to enter the function. Press the
/ keys to enable/disable (ON/OFF) the power on password and confirm with MENU.
To return to standby mode, press [EXIT] key.
Enable the power on password function. Each time the radio is turned on, it will display "Input Password" to prompt for the correct
password.
The default startup password is 000000
6.10 Reset - MENU 56
This transceiver has two Reset modes available: VFO and ALL.
• Reset VFO: all the settings except channels will return to the default settings.
• Reset ALL: all settings will return to the default settings.
Reset VFO
In standby mode, press [MENU] + 56; the screen will display “RESET”.
To Next Page
Loading...