21 PTT ID
•OFF: No ID is sent
•BOT: The selected S-CODE is sent at the beginning
•EOT: The selected S-CODE is sent at the ending
•BOTH: The selected S-CODE is sent at the beginning
and ending
When to Send PTT-ID
Codes are sent during either the beginning or ending of a
transmission.
22 PTT-LT 0|100|200|400|600|800|1000ms PTT-ID Delay (milliseconds)
23 Squelch - Squelch Level
[0 - 9]
Setting the squelch to 0 will open up the squelch
entirely.
Squelch silences the receiver when there is no signal.
- Sensitivity can be varied from .1 to .3 mV on UHF
Sensitivity can be varied from .1 to .2 mV on VHF
24 RX Save OFF| 1:1| 1:2| 1:4
Selects the ratio of sleep cycles to awake cycles (1:1, 2:1, 3:1,
4:1). The higher the number the longer the battery lasts. The
higher number increases the RX sleep cycle, but you may miss
the first few syllables before the RX opens.
25 VOX Switch OFF|ON
When enabled it is not necessary to press the [PTT] key on the
transceiver.
26 VOX Level 1,2,… 9
Adjust the gain level to an appropriate sensitivity to allow
smooth transmission.
27 VOX Delay 0.5sec, …2.0sec
After the VOX function is enabled and the user ceases to
speak, the radio will remain in TX mode for the period of time
defined here.
28 TX Over Time OFF|15,30,…180S
This feature provides a safety switch that limits transmission
time to a programmed value. This will promote battery
conservation by not allowing you to make excessively long
transmissions, and in the event of a stuck PTT switch it can
prevent interference to other users as well as battery
depletion.
29 Language ENGLISH|中文
Set the language type of menu and prompt voice.
•ENGLISH: Display as an English menu with English prompts
for operation.
•Chinese: Display as a Chinese menu and prompt for
operation in Chinese.
30 VOICE OFF [0] | ON [1] Allows audible voice confirmation of a key press
To Next Page
Loading...