31 Menu HangTim 5,10,15……60Sec
Defines the time between entry and exit of the menu. The
counter is activated after the radio enters menu operation. If
there is no physical operation of the radio until the counter
expires, the radio will exit the menu.
32 BEEP PROMPT OFF | ON Allows audible confirmation of a key press
33 Roger Beep OFF|BEEP|Tone1200
Sends an end-of-transmission tone to indicate to other
stations that the transmission has ended.
34 Power On Typ
•LOGO: Predefined Logo.
•MESSAGE: Preset messages are displayed at
power-up. The power-up message can be edited via
menu 36.
•VOLTAGE: Battery voltage displayed at power-on:
e.g. DC 8.2V, 100%
Controls the behavior of the display when
the transceiver is turned on.
35 Power On Ton
•None：No power-on tone
•Tone：Beep at power on
•Voice：Welcome voice prompt at power on
Setting the beep sound at power on
36 Power On MSG WELCOME
Allows customisation of the start-up message at this radio.
Press EXIT to delete forward and enter text or letters via the
keypad.
37 Power On PWD
•OFF: Disable the power-on password.
•ON: Enable the power-on password.
Enable power-on password function, power-on password is
programmed by CPS software
38 Dual Watch
•OFF: Disable the Dual Watch function to display only
the channel number and frequency of the working
channel.
•Double Wait: Monitor [A] and [B] at the same time.
The display with the most recent activity ([A] or [B])
becomes the selected display.
•Signal Wait: Display [A] and [B] simultaneously.
Monitor only the main band [A] or [B].
Monitor [A] and [B] at the same time. The display with the
most recent activity ([A] or [B]) becomes the selected display.
39 MDF-A
•FREQ: Displays programmed Frequency
•NAME: Displays the channel name.
•CH: Displays the channel number
[A] MR/Channel Mode Display Format
Note: Note: Names are allowed to be entered in MENU 1 of
the unit or using the software.
40 MDF-B
•FREQ: Displays programmed Frequency
•NAME: Displays the channel name.
•CH: Displays the channel number
[B] MR/Channel Mode Display Format
Note: Note: Names are allowed to be entered in MENU 1 of
the unit or using the software.
To Next Page
Loading...