41 RP_STE OFF|1s,2s,3s… 10s
This function is used eliminate squelch tail noise when
communicating through a repeater.
42 RPT-RL OFF|1s,2s,3s… 10s Delay the Tail Tone of Repeater (X100 milliseconds)
43
ALERT- 1750Hz Tone-burst
•1000Hz: PTT + SK1 = Transmits 1000Hz Tone Burst
•1450Hz: PTT + SK1 = Transmits 1450Hz Tone Burst
•1750Hz: PTT + SK1 = Transmits 1750Hz Tone Burst
•2100Hz: PTT + SK1 = Transmits 2100Hz Tone Burst
Transmits 1000Hz, 1450Hz, 1750Hz tone bursts to activate
sleeping repeaters. To send out a tone-burst; you
simultaneously will press a key while holding down the PTT.
44 Freq Step 2.5, 5.0, 6.25, 8.33, 10.0, 12.5, 20.0, 25.0, 50.0KHz
Selects the amount of frequency change in VFO/ Frequency
mode when scanning or pressing the
/ keys.
45 Busy Lockout
•OFF: the user can transmit all the time.
•ON: the radio can transmit only if the channel is free.
This option prevents the user from transmitting on channels
that are already in use.
46 Side Tone OFF|ON
This function is used eliminate squelch tail noise between
BaoFeng handhelds that are communicating directly (no
repeater).
Reception of a 55 Hz or 134.4 Hz tone burst mutes the audio
long enough to prevent hearing any squelch tail noise.
47 Alarm Mode
•ON SITE: Sounds alarm through your radio speaker
only
•SEND SOUND: Transmits a cycling tone over-the-air
•SEND CODE: Transmits '119' (911 in reverse?)
followed by the ANI code over-the-air
SITE: Sounds alarm through your radio speaker only
TONE: Transmits a cycling tone over-the air
CODE: Transmits '119' (911 in reverse?) followed by the ANI
code over-the-air
48 PF1 Press
•None:No Function
•Torch On/Off
•Power Select
•Scan On/Off
•VOX On/Off
•Alarm on/off
•Radio on/off
You can program these keys for different functions
To Next Page
Loading...