1. While in VFO mode, set the required frequency, mode, and any other
parameters you desire.
2.
storage.
The audio output level from the computer to the radio should be adjusted
so that the ALC value displayed on the screen is between 30 and 85. The
ALC is within range. Excessively high input signal level will overload the input
correctly, the TX output reading may jump around rapidly under digital
modes - but average power levels will be in the correct range for a clean and
power than other modes to make a contact.
with the "Line input volume" (your TX audio) in the radio. The level of the
31
To Next Page
Loading...
