Although it is possible to connect using individual audio cables, the CE-19
audio path.
Currently the cable being supplied with the G90/S uses FTDI chips in it
You need to download the drivers related to the chipset in your cable.
driver packs. If this is a recent purchase with a blue USB plug start with the
AFTER INSTALLING THE DRIVERS ON THE PC. Insert the 3.5mm plug of the
Insert the 8-pin ACC cable provided with the CE-19 into the ACC port at the
rear of the G90/S base unit and the other end into the corresponding port
Some PCs have separate 3.5mm audio out and audio in ports, more
modern ones come with a single (4-connector) socket wired to take a
smartphone type headset. The cable from the CE-19 has both send and receive
audio on the three-pin plug, so depending upon your PC, some form of
adapter may need to be bought or built.
1.
2.
3.
Set the G90/S to "Line input" mode (i.e. take the audio from the ACC socket
rather than from the hand microphone.)
you are going to use. For most digital modes, that is USB.
4.
5.
36
To Next Page
Loading...
