Xilinx Alveo U250 Getting Started

Idcode byte[3] 21
Idcode byte[4] 10
Enabled bitstream guard. Bitstream will not be loaded until flashing is
finished.
Erasing flash...................................
Programming flash...................................
Cleared bitstream guard. Bitstream now active.
Successfully flashed Card[0]
1 Card(s) flashed successfully.
Cold reboot machine to load the new image on card(s).
If you have previously updated the card, you will see a message similar to the following:
Probing card[0]: Shell on FPGA is up-to-date
0 Card(s) flashed successfully.
6. Cold boot your machine to load the new rmware image on the FPGA.
IMPORTANT! Be sure to fully power o the machine and then power it on again. The image will not boot from
ash if the machine is only rebooted.
IMPORTANT! Assurez-vous d'éteindre complètement la machine, puis de la rallumer. L'image ash ne
démarrera pas si la machine n'est pas redémarrée.
WICHTIG! Schalten Sie das Gerät vollständig aus und wieder ein. Das Image startet nicht von Flash, wenn der
Computer nur neu gestartet wird.
The installaon for deployment is now complete. You can go directly to Chapter 5: Card Bring-Up
and Validaon to validate the installaon.
Related Informaon
Generang the xbmgmt ash --update Command
Chapter 4: Installing the Deployment Software
UG1301 (v1.5) June 3, 2020 www.xilinx.com
Getting Started with Alveo Accelerator Cards 26
Send Feedback

Xilinx Alveo U250 Specifications

General

Brand	Xilinx
Model	Alveo U250
Category	Computer Hardware
Language	English