AC701 Getting Started Guide www.xilinx.com 23
UG967 (v3.0) July 10, 2013
Advanced Bring-up with Base Targeted Reference Design
Hardware Bring Up
All procedures listed in the subsequent sections require super-user access on a Linux PC.
When using the Fedora 16 LiveDVD provided with the kit, super-user access is granted by
default due to the manner in which the kernel image is built. If not using the LiveDVD, it
is important to ensure that super-user access is granted.
1. With the host PC powered off, insert the AC701 board into the selected PCIe x4 (or
wider) edge connector (see Figure 16). The PCI Express specification allows for a
smaller lane width endpoint to be installed into a larger lane width PCIe connector.
X-Ref Target - Figure 16
Figure 16: AC701 Board Installed in a PCIe x16 Connector
To Next Page
Loading...
