24 www.xilinx.com AC701 Getting Started Guide
UG967 (v3.0) July 10, 2013
Advanced Bring-up with Base Targeted Reference Design
2. Connect the 12V ATX power supply 4-pin connector to the board as shown in
Figure 17.
Note:
A 6-pin ATX supply cannot be connected directly to the AC701 board; A 4-pin adapter is
necessary in this instance.
3. To avoid loose contact issues, make sure the connections are secure. Turn ON the SW15
switch, apply power to the system, insert the Fedora LiveDVD, and change the boot
order to boot from the DVD.
X-Ref Target - Figure 17
Figure 17: Power Supply Connection
To Next Page
Loading...
