Need help?Do you have a question about the Xilinx AC701 and is the answer not in the manual?
General| Form Factor | ATX |
|---|---|
| FPGA Family | Artix-7 |
| DDR3 Width | 32-bit |
| Ethernet | 10/100/1000 Mbps |
| USB | USB 2.0 |
| Storage | MicroSD card slot |
| Configuration | JTAG, SPI |
| Primary Interface | PCIe x4 |
| User I/O | LEDs |
| USB Ports | 1 |
| FPGA | XC7A200T |
General introduction to the AC701 board and its purpose.
Points to external resources for additional AC701 board information.
Lists the main hardware features available on the AC701 board.
Detailed descriptions of each hardware component and its functionality.
Description of the main Xilinx Artix-7 FPGA on the AC701 board.
Explains the methods for configuring the FPGA on the AC701 board.
Details the 1 GB DDR3 SODIMM memory module on the AC701 board.
Describes the 256 Mb Quad SPI flash memory for configuration and data storage.
Explains the onboard USB-to-JTAG module for configuration and debugging.
Details the clock sources available for the FPGA logic on the AC701 board.
Describes the GTP transceivers for high-speed serial interfaces.
Details the 4-lane PCI Express edge connector for data transfer.
Describes the SFP/SFP+ connector for network connectivity.
Details the Ethernet PHY for network communication.
Details the HDMI output functionality using an ADV7511 transmitter.
Describes the 2-line by 16-character LCD display.
Explains the I2C bus switch for controlling downstream devices.
Covers general purpose user I/O capabilities.
Details the slide switch for controlling board power.
Explains the pushbutton to initiate FPGA reconfiguration.
Describes the DIP switch for selecting FPGA configuration modes.
Details the FMC High Pin Count connector for mezzanine card expansion.
Explains how to control the VCCO_VADJ voltage for FMC cards.
Details the circuit for controlling and monitoring the FPGA cooling fan.
Describes the header for XADC interface and voltage source options.
Default settings for the user GPIO DIP switch SW2.
Default settings for the FPGA configuration mode DIP switch SW1.
Lists the default configurations for various jumpers on the AC701 board.
Pinout diagram for the FMC HPC connector on the AC701 board.
Lists the Xilinx Design Constraints (XDC) for AC701 board designs.
Step-by-step guide for installing the AC701 board into a PC chassis.
Physical dimensions of the AC701 evaluation board.
Operating temperature, humidity, and voltage specifications.
Links to Xilinx support resources like documentation and forums.
Information on Xilinx design support and troubleshooting services.
List of Xilinx documents and vendor websites for further information.
Formal statement of the product's compliance with EU directives.
Details compliance with EMC standards like EN 55022 and EN 55024.
Lists safety standards like IEC 60950-1 for IT equipment.
To Next Page
