Xilinx AC701 - Appendix A: Default Switch and Jumper Settings; User GPIO DIP Switch SW2

AC701 Evaluation Board www.xilinx.com 79
UG952 (v1.3) April 7, 2015
Appendix A
Default Switch and Jumper Settings
User GPIO DIP Switch SW2
See Figure 1-2, page 10 callout 23 for location of SW2. Default settings are shown in
Figure A-1 and details are listed in Table A-1.
X-Ref Target - Figure A-1
Figure A-1: SW2 Default Settings
Tabl e A -1 : SW2 Default Switch Settings
Position Function Default
1 GPIO_DIP_SW0 OFF
2 GPIO_DIP_SW1 OFF
3 GPIO_DIP_SW2 OFF
4 GPIO_DIP_SW3 OFF
UG952_aA_01_100712
SW2
1
OFF Position = 0
ON Position = 1
234
Send Feedback