Xinje DS3E Series

57
B. The code contents
Code
Descrption
Standby
Servo OFF (motor power OFF)
Run
Servo ON (motor power ON)
Reset
Servo re-power
Forward Run Prohibited
P-OT ON. Please refer to 5-2-4 “Overtravel Limit”
Reverse Run Prohibited
N-OT ON. Please refer to 5-2-4 “Overtravel Limit”
 Position control mode
A. Bit display contents
Bit Data
Description
P5-38
Positioning Completed
(/COIN)
Light when set position and actual position is the same.
Positioning accomplishment width: P5-00 (unit: command
pulse)