Xinje DS5E Series - Page 43

P+ P- R S T U V W PBPE
POWER MOTOR
R/S/T
Power supply input of
main circuit
3-phase AC 380~440V, 50/60Hz
PE Connect to ground -
U, V, W Motor terminals
Connect the motor
Note: the ground wire is on the cooling fin,
please check it before power on!
P+, PB
External regenerative
resistor
Connect regenerative resistor between P+ and
PB, P0-25= power value, P0-26= resistor
value
P+, P- Bus terminal
Real-time bus voltage can be measured.
Please pay attention to the danger.
R S T P1 P+ U V W PEP-
 DS5E-422P0-PTA
Terminal Function Explanation
R, S, T
Power supply input of
main circuit
3-phase AC 380~440V, 50/60Hz
PE Connect to the ground -
U, V, W Motor terminals
Connect the motor
Note: the ground wire is on the cooling fin,
please check it before power on!
P1, P+, P-
P1, P-: external brake
unit
It is necessary to select the braking unit and
braking resistance. The input terminal of the
braking unit is connected to P1 and P -, and
the braking resistance is connected to the
output of the braking unit
P1, P+: the terminals are
short connected
After removing the short connector, the DC
reactor can be connected in series to suppress
the high-order harmonic of the power supply
and improve the output DC waveform
P+, P-: bus terminal
The real-time voltage of the bus can be
measured. Please pay attention to the danger.
36