1. Do not touch the rotating part of the motor after the driver is running. There is a danger of injury.
2. Please pay attention to the test run of the motor once, do not connect the motor with the machine,
there is the possibility of injury.
3. After connecting the machine, please set the appropriate parameters before running, otherwise it
may cause the machine out of control or failure.
4. In operation, do not touch the radiator, there is a risk of scald.
5. Under power-on condition, do not change the wiring, there is a risk of injury.
6. Do not switch power frequently. If you need to switch power many times, please control it once in 2
minutes.
Maintenance and inspection
1. Do not touch the inside of servo driver and servo motor, otherwise it may cause electric shock.
2. When the power is started, it is forbidden to remove the driver panel, otherwise it may cause electric
shock.
3. Within 10 minutes of power off, the terminal should not be contacted. Otherwise, the residual
voltage may cause electric shock.
1. Do not cross the power line and the control signal line from the same pipeline, nor tie them together.
The power line and the control signal line are separated by more than 30 centimeters.
2. For signal line and encoder (PG) feedback line, please use multi-stranded wire and multi-core
stranded integral shielding line. For wiring length, the longest signal input line is 3 meters and the
longest PG feedback line is 20 meters.
To Next Page
Loading...
