2. Reset must be performed in the following cases:
⚫ The brake pad and brake pad wear sensor are replaced.
⚫ The brake pad indicator lamp is on.
⚫ The brake pad sensor circuit is short, which is recovered.
⚫ The servo motor is replaced.
The operation guidelines of the EPB function are shown as below:
1. Enter the EPB menu and choose relevant models according to the
vehicle being tested.
2. Follow the instructions displayed and press YES after completing the
instructions shown.
Figure 5-4 Sample of EPB function (screen 1)
3. Enter the Enter maintenance mode menu and release the
handbrake brake. And press OK after completing the instructions
shown.
To Next Page
Loading...
