When you open the report, located in the header of the table is the workshop information you filled in advance in the
system setup, then the information of the vehicle, as shown below:
Note:
The vehicle information is allowed to edit by clicking the pen icon on the right side of the picture shown above.
You also can click "Print PDF Report" at the bottom right corner to output the pdf report. If you need to close the report
tap on the button “Exit”.
Please follow the below steps to print your report▼
Step 1: Install an APP that can connect to your target printer. Add the printer and input the IP address of the printer in the
APP, or you can contact the XTOOL support team (support1 / support2@xtooltech.com) for help.
To Next Page
Loading...
Need help?
General
