WARNING:
• Always disconnect and lock out power to the driver before you perform any installation
or maintenance tasks. Failure to disconnect and lock out driver power will result in
serious physical injury.
The main station panel is equipped with a main station disconnect for completely
powering down the system. This panel also provides individual circuit breaker service
disconnects for each pump. These disconnects are accessible without disengaging the
main station disconnect to ensure that operation of the system is not interrupted during
individual pump service. In both situations (complete station or individual pump power
down), provisions for lockout / tagout capability have been provided.
The main station disconnect has a door interlocking feature that utilizes a handle that
allows for padlocking.
The individual circuit breaker disconnects are accessible through an inspection/service
window that has an integrated locking tab feature. The use of a lockout scissor clamp is
highly recommended to properly lockout any of these individual disconnects.
1 Introduction and Safety
6 TECHNOForce e-HV Mechanical Installation, Operation, and Maintenance Manual
To Next Page
Loading...
