Need help?Do you have a question about the Xylem CentiPro Aquavar IPC and is the answer not in the manual?
Guidance on initiating and configuring the No Flow Power Calibration process.
Detailed settings for restart difference, minimum times, and flow check parameters.
Final steps for executing and verifying the No Flow Power Calibration.
Access Quick Menu, select Startup Genie, choose Pump Protection.
Set Duplex Restart Difference, Flow Check Window, and Low Time.
Set Duplex Flow Check High Time and enable the calibration.
Run No Flow Power Calibration on the lag pump drive.
Cross-reference Genie settings for motor details.
Parameters for feedback, setpoints, and pump protection.
General| Brand | Xylem |
|---|---|
| Model | CentiPro Aquavar IPC |
| Category | Controller |
| Language | English |
To Next Page