Xylem SI Analytics TITRONIC 500 - Initial Filling or Rinsing of the Entire Interchangeable Unit

99
2.7.4 Initial Filling or Rinsing of the Entire Interchangeable Unit
While the initial filling or rinsing programme is being run, please place a sufficiently dimensioned waste
vessel under the titration tip.
Initial filling of the interchangeable unit is done using the «rinsing» program.
Fig. 19
On the main menu (Fig. 19), press <MODE> to navigate to the methods/system (Fig. 20).
Fig. 20
Pressing <↑> twice will take you to the «Rinsing» selection immediately (Fig. 21).
Fig. 21
Confirm the selection by pressing <ENTER>/<OK>.
At this point you can select the number of rinsing cycles (Fig. 22).