SonTek, a Xylem brand
RiverSurveyor S5/M9 System Manual (February 2013)
97
Profile Extrapolation - Top: Number of cells used in
extrapolation
extrapolation_Bottom_nFitType
Profile Extrapolation - Bottom: Fit equation type (0 =
Constant fit; 1 = Power fit)
extrapolation_Bottom_nEntirePro
Profile Extrapolation - Bottom: Fit (0 = Use entire pro-
file; 1 = User selected number of cells)
extrapolation_Bottom_dExponent
Profile Extrapolation - Bottom: Power fit exponent
extrapolation_Bottom_nCells
Profile Extrapolation - Bottom: Number of cells used
in extrapolation
extrapolation_nDiscardType
Method for discarding cells at the bottom of the pro-
file (0 = user selected number of cells; 1 = percent-
extrapolation_nDiscardCells
Number of cells discarded
extrapolation_dDiscardPercent
Percentage of profile discarded
User input measurement quality
Enable or disable SmartPulse
HD
0 = Use User Input Temperature; 1 = Use Measured
Temperature
0 = Use Calculated Sound Speed; 1 = Use User Input
Sound Speed
Units for above parameters
Stationary Structure
Water depth at station input by user
water_Surface_To_Bottom_Of
Slush
Distance from the surface of the water to the bottom
of the slush ice
Transducer screening distance (similar to RSL)
User-input auxiliary gauge height
User-input time for gauge height
Whether station is an island edge or not
Number of samples in station
Location of start of station
Location of center of station
Location of end of station
Station depth as measured by system
Number of seconds actually measured at each station
Extrapolation type for top fit
Whether using a set number of top cells or not in ex-
trapolation
Exponent used in top extrapolation